Silverlon® Antimicrobial Tubular Digit Sleeves

Directions for Home Use

How To Apply

1. Silverlon® Antimicrobial Tubular Digit Sleeve Bandages are ideal for application to wounds and burns located on the fingers and toes. This versatile tubular bandage can be applied to wounds, burns, blisters, and bites.

2. Cut to full length of digit as appropriate to cover site and apply.

3. Wet Dressing with Water. Limit direct exposure to SALINE.

4. Dressing may be removed, rinsed and reapplied again for up to 7 days.

Caution: DO NOT allow the Dressing to restrict circulation.

Dressing effectiveness decreases if used with products containing petrolatum, iodine, hydrogen peroxide, or saline.

Better technology.  Better outcomes.™

Silverlon® Wound Care Dressings General Directions for Home Use

1. Silverlon® Wound Care dressings should be sized to fit into the wound bed and up onto ½″ (one-half inch) of normal skin around the wound. (The Silverlon® dressing should last for up to 7 days if properly cared for as described below).

2. A secondary cover dressing of choice to be placed over the Silverlon® dressing. Use tape, self stick gauze, tubular stretch knit or compressive wrap dressings to hold the Silverlon® dressing in place.

3. Clean water for daily rinsing of Silverlon®. Your caregiver may have given you saline or sterile water for rinsing out your wound, if so, use it for your wound and not for the dressing.

Optional: For heavily draining wounds, wound cleansers may be considered, such as Shur -Clens®, Saf – Clens®, Curasol®, Dermagran®, or Biolex®.

Your goal is to keep your wound and the Silverlon® dressing clean, moist, and covered. Recommend washing hands with warm water and soap before and after dressing change. The Silverlon® may be worn while showering unless otherwise directed by your physician or nurse. Please check with physician or nurse for exact showering directions. Soaking in a bathtub is not recommended.

1. Do not use saline solutions directly on Silverlon®, as the chloride ion inhibits silver ion release.

2. Daily soaking and spraying with wound cleansers (optional, as listed above) may help remove wound debris and extend the life of the Silverlon® dressing.

1. Remove and dispose of the outer absorbent cover dressings.

2. Gently remove Silverlon®, if any sticking occurs see warning instructions below.

3. Rinse Silverlon® thoroughly with clean water being sure to rinse away any exudate that maybe on the dressing (You may stretch the dressing by its corners to open up its weave to help loosen the exudate from the cloth), gently squeeze out excess water, and reapply to wound while moist.

4. Apply fresh cover dressings as per instructed by your physician or nurse.

1. Remove Silverlon® prior to MRI procedures.
2. Do not remove the Silverlon® Wound Care Dressing while dry or if Silverlon® is sticking. If sticking occurs, rewet and saturate the Silverlon® dressing waiting until it can easily be removed. If problems occur, including swelling, severe redness or sharply increased pain, contact your physician.

For a printer friendly version of this Silverlon® Tubular Wound Dressing Instructions Page, please click here

All of the Silverlon® Wound Care, Burn Care, and Surgical Care Products
listed on this website are FDA Cleared.

Copyright © 1998-2008 Argentum Medical, LLC.
All Rights Reserved.